Evolve T-100-R Manual de usuario

T-100-R Operation Guide

Page 10Screen TimeoutMinimized Screen. Set the display timeout time in seconds. Options are 0 or 15 to 120 (default set to 0 seconds). This is the tim

Page 11Operation GuideAway SetpointsAway setpoints are used when the thermostat is set to the setback or away mode.Z-Wave InstallThis menu item allows

Page 12Operation GuideThermostat OperationMinimum Run Time (MRT)The thermostat has a Minimum Run Time after the start of any heating or cooling call.

Page 13Operation GuideZ-Wave InstallationZ-Wave controllers from various manufacturers may support the Z-Wave Thermostat General V2 Device class used

Page 14Operation GuideFCC/ICINFORMATION TO USERThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two condition

www.evolvecontrols.com

Page 2Table of ContentsMain Thermostat Screen 3Setting the Heating or Cooling Temperature Setpoint 4Setting the System Mode: Off, Heat, Cool, Auto

Page 3Operation GuideMain Thermostat Screen MENU COOL MODE 72 H AUTO FAN HOLD 7475 C 4:30 PM SYS OFF ECON HOLD

Page 4Setting the Heating or Cooling Temperature SetpointOperation Guide 64 DONE HEATING SETPOINT 4:30 75 MENU HEA

Page 5Setting the System Mode: Off, Heat, Cool, AutoPress Mode button tochange system modeSystem Modes• OFF: System is off. No heating or cooling wi

Page 6Setting Fan Mode and System Status IndicatorsOperational Fan ModeFan Cycler. If the Fan Cycler feature is enabled in the Installer Setup, the a

Page 7Operation GuideMenu Selection 4:30 PM Menu Selection Select Energy Usage Utility Setup Messages Schedules Done 75 M

Page 8Operation Guide...as per that days schedule stored in the thermostat. “Hold” mode stops schedule operation and holds the current setpoints until

Page 9Operation GuideUser Settings Menu Items• Set Clock  go to the clock setting screen• Filter Service  go to the lter timer setup screen•